Faux-Stiks wall decals
December 2, 2006

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

Last Updated

Stik-ables™ Instructions

There are two extremely important factors that must do.

1. Clean the surface you are going to apply the Stik-ables. THIS INCLUDES WALLS. Use a warm cloth to clean the area but dot use soap or other chemicals because they may keep the adhesive from sticking.

2.Apply plenty of pressure to the entire stik-able especially the edges. This is key to remember to do this to each one.

***Be sure to wipe down all surfaces with a warm cloth (DO NOT USE SOAP OR OTHER CLEANING PRODUCTS) including walls, and allow to dry completely before applying your Stik-ables™. If you have recently painted be sure the paint is cured. Smoke, dust and other dirt particles will affect the adhesion to the surface. Stik-ables™ applied to unclean surfaces will not adhere well and may cause the edges of the Stik-ables™ to lift or not stick to the surface.

 To apply your small Stik-ables™:

  1. Make sure you have wiped down the surface with a warm cloth and allow to dry completely.
  2. Gently peel the excess vinyl from the sheet, leaving only the Stik-ables™.
  3. Gently peel the logo or mascot off the sheet.
  4. Press the logo to the surface with your hand or a soft cloth.
  5. Re-position if necessary.
  6. Stik-ables™ are pressure activated.  Be sure to apply pressure to the entire Stik-able™ with a soft cloth.

To apply your giant Stik-able.

** It is best to have 2 people when applying the giant Stik-ables.

  1. Make sure you have wiped down the surface with a warm cloth and allow to dry completely. (even if you recently painted)
  2. Gently peel the excess vinyl from the sheet, leaving only the Stik-ables™.
  3. Gently begin peeling the Stik-able off with someone on both sides. Be extra gentle around corners and the registration mark - you may want to pre-lift those areas.
  4. Place the Stik-able onto to the wall with minimal pressure at first, if needed gently pull the Stik-able from the wall and reposition.
  5. Smooth the Stik-able out with your hand or a soft cloth (take any rings off is using hand).
  6. Apply pressure with a cloth all over the Stik-able especially the edges. The adhesive is pressure sensitive so be sure not to miss this step.

That's it! Enjoy. You will find our Stik-ables are the easiest decal you have ever worked with.

If you are using this simply as a party decoration keep the liner and place back on the liner and you should be able to use it a couple more times.

Stik-ables™ are for non-commercial home use only.
Federal trademark laws prohibit use of this product on other products for re-sale without approval from their universities.